BENNER NAWMAN
REBAR CUTTERS AND BENDERS


BENNER NAWMAN MODEL  DCC-16L
Here is the ultimate cordless portable rebar cutter from Benner-Nawman, Inc. Weighing only 13 pounds and easily held in one hand, the CORDLESS DCC-16L can be used anywhere and any time. It cleanly shears number #5 (5/8") grade-60 rebar. It is also equally suitable for mesh: its small cutting head rotates 360 degrees and can fit into tight spots where other tools won't go. This tools comes complete with a carrying case, battery charger, battery, a maintenance manual, tools and a pint of hydraulic oil.

BENNER NAWMAN MODEL DC20WH
The DC-20WH is our largest selling portable rebar cutter. It is an electrical/hydraulic tool that only draws 10 amps but delivers 15 tons of cutting pressure. It will cut any size rebar up to #6 (3/4") - 60 grade in 3 seconds. At only 26 1/2 lbs. it is the ideal tool to be carried out to the construction site.



BENNER NAWMAN MODEL DC-25X
Many contractors choose to move up to the DC-25X because of its capability to handle up to #8 (1") - 60 grade rebar. Drawing only 12 amps it will deliver 30 tons of cutting pressure. Unlike using torches, our rebar cutter will not damage the rebar from heat transference and it is much quicker and more economical than disk or abrasive type cutters.



BENNER NAWMAN MODEL DBD-25X
This is the largest selling portable rebar bender in the U.S. This fully mechanical bender can make 180 degree bends in #7 (7/8") - 60 grade rebar in less than 6 seconds. The entire unit weighs less than 200 lbs. and can be run off any AC generator drawing 12 amps (110v/115v, 50-60 Hz). This is a reliable workhorse for necessary rebar field adjustment. Two separate angles may be preset. Shown with optional stand and foot pedal.


CONTACT US                           CLOSE THIS WINDOW